In-circuit or In-system programming is the technique whereby the programmable device gets programmed only after its placement on the circuit board. It is quite possible to reprogram today's microcontrollers as well as external memory chips, without removing them in entirety from the board. This eliminates the additional handling process required during manufacturing to program the device externally.
In-system programming solutions are beneficial in a number of ways. Some of them are listed below. Go through these and get enlightened:
• Convenience of operation: In-system programmers allow programming of electronic chips, even while they are installed within the computer system. This increases the convenience of operation to a great extent for the user.
• Short cycle of development: These tools combine program integration and testing within a single phase of production, thus shortening the manufacturing cycle of facilities.
• Low risks of damage & failure: In-circuit programmers entail a safe procedure and eliminate the risks of leads damage at the surface of mount devices and reduce the likelihood of damage to devices through ESD or electrostatic discharge.
• Eliminates plausible delays: These programmers enable manufacturers to do away with delays, as they need not resort to the purchase of pre-programmed electronic chips from the distributor. With these devices they can instantly start up.
• Amenable to production changes: ISP makes the procedure of adding changes in design or codes feasible in the long run.
• ATE-compatible: In-system programmers make it possible to use ATE or automatic test equipment for performing multifarious operations while maintaining a normal test flow of production.
Avr JTAG programmer is a type of in-system programmer that supports debugging and examination as well. It is an effective tool and can be used for large devices too. Hence, get this programmer today itself and ease up the process to a great extent.
In-system programming solutions are beneficial in a number of ways. Some of them are listed below. Go through these and get enlightened:
• Convenience of operation: In-system programmers allow programming of electronic chips, even while they are installed within the computer system. This increases the convenience of operation to a great extent for the user.
• Short cycle of development: These tools combine program integration and testing within a single phase of production, thus shortening the manufacturing cycle of facilities.
• Low risks of damage & failure: In-circuit programmers entail a safe procedure and eliminate the risks of leads damage at the surface of mount devices and reduce the likelihood of damage to devices through ESD or electrostatic discharge.
• Eliminates plausible delays: These programmers enable manufacturers to do away with delays, as they need not resort to the purchase of pre-programmed electronic chips from the distributor. With these devices they can instantly start up.
• Amenable to production changes: ISP makes the procedure of adding changes in design or codes feasible in the long run.
• ATE-compatible: In-system programmers make it possible to use ATE or automatic test equipment for performing multifarious operations while maintaining a normal test flow of production.
Avr JTAG programmer is a type of in-system programmer that supports debugging and examination as well. It is an effective tool and can be used for large devices too. Hence, get this programmer today itself and ease up the process to a great extent.
No comments:
Post a Comment